LED Solar Street light with motion sensor VIDEX VL-SLSO-082-S is designed for autonomous illumination of sidewalks, park paths, and local roads. The lamp is charged by a solar panel and powered by a built-in rechargeable battery, without connection to the electrical network. Using this lamp, you will be completely independent of potential power outages at home or at your country house, as the battery charges throughout the day from sunlight, allowing it to operate autonomously for up to 12 hours. This outdoor lamp is ideal for use anywhere there is no access to the electrical grid or where power supply is limited or unstable.

ADVANTAGES AND FEATURES OF THE LAMP:
• Fully autonomous operation with no electricity costs;
• High-efficiency solar panel 6V, 20W;
• LED light source providing high-quality, even, and directed illumination;
• Built-in LiFePo4 battery, 64Wh, 20 000mAh, with a long lifespan >2000 charge/discharge cycles;
• Long service life with no maintenance required;
• Dust and water protection IP65, suitable for all weather conditions;
• Impact resistance rating IK07;
• Built-in motion sensor and remote control for convenience;
• Integrated smart internal circuitry with overcharge, over-discharge, and overvoltage protection;
• Long battery runtime of up to 12 hours;
• Quick, convenient, and reliable installation.

INSTALLATION RECOMMENDATIONS
Read the user manual before installation and use. The lamp is intended to be mounted on a pole or other bracket (maximum diameter 60 mm) at an angle of approximately 20° to the ground. Recommended mounting height is 4–6 m. Install the lamp in locations with sufficient sunlight. Do not install the lamp with the solar panel facing north.

Note:
- Before first use, ensure the lamp completes a full charge cycle (approximately 5–8 hours) under direct sunlight.
- Avoid shading the solar panel by trees, buildings, or other objects, as this may reduce performance.

USER INSTRUCTIONS
Read all important notes before use. To activate the lamp, remove the transparent plastic film from the remote control and then press the «WAKE UP» button. Once activated, the lamp operates automatically as follows:

a) When ambient light is below 15Lx – the light turns on, and the battery does not charge;
b) When ambient light is above 25Lx – the light turns off, and the solar panel converts sunlight into electricity to charge the battery. A flashing red light indicates charging in progress. A steady green light indicates the battery is fully charged.

REMOTE CONTROL
The remote control allows you to select the desired mode and adjust the lamp’s brightness. Button functions:
1. Turn on: Press «ON» once to switch on the light.
2. Turn off: Press «OFF» once to switch off the light. Press twice to enter sleep mode;
3. Brightness 100% of maximum;
4. Brightness 50% of maximum;
5. Increase brightness by 10%;
6. Decrease brightness by 10%;
7. *Motion sensor modes: Press to switch the lamp to motion detection modes:
7.1. Mode A: Press «M», the lamp responds with a single flash. The light turns on at 100% brightness when motion is detected and dims to 20% after 20 seconds if no motion is detected;
7.2. Mode B: Press «M», the lamp responds with a double flash. The light turns on at 100% brightness when motion is detected and turns off after 60 seconds if no motion is detected.
8. *Automatic mode: Press «AUTO» to cancel all previous settings and activate automatic operation: first 3 hours at 100% brightness, next 3 hours at 70%, and the remaining time at 30% until dawn or until the battery discharges;
9. Wake up: After installation, press «WAKE UP» to activate the lamp, after which it will operate automatically;
10. *Auto-off after 3 hours: The light turns off 3 hours after activation;
11. *Auto-off after 5 hours: The light turns off 5 hours after activation;
12. *Auto-off after 8 hours: The light turns off 8 hours after activation.

*Once a lighting mode is selected, there is no need to select it again. The lamp remembers the chosen mode and applies it every evening. Additional operating recommendations are provided in the user manual.

Before long-term storage, charge the battery to ensure future performance. For long-term storage, it is recommended to keep the battery charge at about half of its capacity to extend its lifespan. Do not store the battery in a discharged state. Do not store the lamp with a discharged battery. To maintain optimal performance, clean the solar panel every 3–4 months. Clean only with soft, dry cloths. The lamp comes with a 2-year warranty.