LED Solar Wall Light with motion sensor VIDEX VL-WLSO-025-S is a modern and efficient lighting fixture designed for independent illumination of residential areas, private yards, as well as for highlighting walls and architectural structures. The light operates on a built-in battery and does not require connection to the mains; it is charged via a solar panel. This product is intended for outdoor use only.

ADVANTAGES AND FEATURES OF THE LIGHT:
- high-efficiency solar panel and complete autonomy
- flexible adjustment of lighting operation modes
- equipped with a built-in LiFePO4 battery
- long battery lifespan of >2000 charge/discharge cycles
- built-in infrared motion sensor (PIR sensor)
- dust and moisture protection rating IP54
- impact protection class IK06
- beam angle 60°
- long operating time of up to 12 hours on battery power

PACKAGE CONTENTS:
- Light fixture
- Mounting bracket
- Expansion screw (2 pcs.)
- Threaded clamp (2 pcs.)
- Individual packaging

INSTALLATION INSTRUCTIONS
Read the user manual before installation and use. The light fixture and solar panel are integral parts of the product. It is intended for installation on walls, fences, or building facades. The recommended installation height is 2–4 m. The product should be installed in locations with strong and sufficient sunlight.

To install, follow these steps:
a) Drill holes in the mounting surface and insert the expansion screws.
b) Install the bracket.
c) Attach the light to the bracket; adjust the tilt angle of the solar panel so that sunlight reaches it as perpendicular as possible. Tighten the side clamps.
d) Press the switch on the light to turn it on and select the operating mode. To adjust the direction of the light, rotate the light source by 180 degrees.
e) To set the light for wall illumination, select the «Auto» mode.

OPERATING INSTRUCTIONS
The light control system automatically charges the battery during the day (>10Lx) and discharges it at night (<5–10Lx). Ambient temperature for charging must be above 0°C, and for discharging above –10°C.

Note:
- Before regular use, make sure the light is fully charged for 6 hours under direct sunlight.
- Avoid shadows from trees, buildings, or other objects falling onto the solar panel, otherwise performance will be reduced.

OPERATING MODES:
1) Sensor standby mode with light. When motion is detected – 100% brightness; when no motion is detected – 3% brightness. The light turns off 20 seconds after the last detection.
2) Sensor mode. When motion is detected – 100% brightness; when no motion is detected – the light is off. The light turns off 20 seconds after the last detection.
3) Auto mode. Operates at 60% brightness for the first 30 minutes, 50% for the next 1.5 hours, 30% for the next 4 hours, and 10% for the remaining 8 hours or until the battery is discharged.
4) OFF mode. Press again to turn off: the light enters the off state.

For long-term storage, it is recommended to maintain the battery charge level at about half capacity to extend its lifespan. Do not store with a discharged battery. To maintain original performance, clean the solar panel every 3–4 months. WARNING! Do not look directly into the LED beam.

The light comes with a 2-year warranty.